Toshiba B-EP Series Interface Specification page 201

(2) Rounded corners of a rectangle ≠ 000
(X ,Y )
1 1
Radius
Line width + 1 dot
Notes
(1) In line designation, a horizontal line, vertical line, or slant line A or B is drawn according to
the start and end point coordinates. However, in the case of the compatible mode for the
B-SP series, when the coordinates which make a slanted line are specified, a rectangle is
drawn.
(2) The result is the same even if the start and end point coordinates are reversed.
(3) The start and end point coordinates must be set so that the result of line drawing will be
within the effective print area set by the Label Size Set Command
([ESC] D).
(4) Designation of the radius of the rounded corner is effective only when the type of line is
set to 1 (rectangle) or 3 (rectangle with dots skipped). When the type of line is set to 0 or
2, designation of the radius is ignored.
(5) When the type of line is set to 1 or 3 and the radius of the rounded corner is set to 000 or
omitted, a normal rectangle is drawn.
(6) On the following condition, a circle is supposed to be drawn:
| X - X
2 1
2
(7) Only numerals are available in the coordinate input area.
| | Y - Y |
2 1
≤ [Radius of rounded corners]
=
2
5-31
CHAPTER 5 TPCL MODE (INTERFACE COMMANDS)
(X
2
B-EP Series
Line width + 1 dot
,Y )
2