Toshiba B-EP Series Interface Specification page 334

Explanation
(1) Number of labels to be issued
If increment/decrement is not specified, the same data will be printed on the
designated number of labels.
If increment/decrement is specified, the designated number of labels will be printed
while incrementing/decrementing the designated drawing area one by one.
* The increment/decrement designation is effective until the Image Buffer Clear
Command ([ESC] C) is transmitted.
(2) Type of sensor
No sensor:
Printing takes place according to the parameter designated by the Label Size Set
Command.
Reflective sensor:
Printing takes place according to the parameter designated by the Label Size Set
Command. However, the black mark provided on the back side of the tag paper is
automatically sensed by the reflective sensor and the paper position is finely
adjusted for every piece.
Transmissive sensor:
Printing takes place according to the parameter designated by the Label Size Set
Command.
transmissive sensor and the paper position is finely adjusted for every piece.
(3) Tag rotation designation
The origin of coordinates and print direction vary according to the designation of tag
rotation.
Bottom first printing
Origin of
coordinates
(0, 0)
Effective
print length
X
0
Y
However, the label-to-label gap is automatically sensed by the
Backing paper
Label
Label
pitch
S a m p l e
Effective
print width
Paper feed direction
[Label]
5-164
CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)
Origin of
coordinates
(0, 0)
Effective
S a m p l e
print length
Effective
print width
X
0
Y
[Tag]
B-EP Series
Black mark
(Back side of paper)
Tag
Tag
pitch
Paper feed direction