Toshiba B-EP Series Interface Specification page 446

6.8 COMMANDS RELATED TO WRITABLE CHARACTERS
6.8.1 WRITABLE CHARACTER DATA STORE COMMAND
Function Stores writable characters and logos into flash memory.
Format [ESC] XD; aa, bbb --- bbb [LF] [NUL]
Term aa:
bbb---bbb:
Explanation
Graphic
height
24 dots
(1) The writable character data should be separated into units of 8 dots and sent in the
(2) The writable character data is 00H to FFH.
(3) The number of dots of a writable character width and a writable character height
(4) Max. 50 types of writable character data can be stored. The writable character
(5) Writable character data is assigned from FF40H to FF71H. Therefore, to read the
(6) A new writable character can be stored in codes which have been stored in an
Writable character code
FF40H to FF71H
Writable character data (Fixed at 72 bytes)
Graphic width 24 dots
8 dots 8 dots
above order (1 to 72).
are fixed at 24 dots. Dots with no data are transmitted as data 0. 72-byte data
should be sent.
data is backed up in memory (even if the power is turned off).
code, the code (2 bytes) which was stored by this command should be designated.
already existing code.
CHAPTER 6 LABEL MODE (INTERFACE COMMANDS)
[ESC] XD
00H
1
00H
4
EFH
67
3EH
70
8 dots
6-65
B-EP Series
60H 00H
2 3
70H 00H
5 6
•
•
•
•
•
•
80H 00H
68 69
00H 00H
71 72