Toshiba B-EP Series Interface Specification page 685

LCD Message of the
No.
Upper Line
(English)
FLASH MEM FULL
14
EEPROM ERROR
15
LOW BATTERY
16
AMBIENT TEMP ERR
17
BATT. TEMP ERROR
18
HIGH VOLT. ERROR
19
SYSTEM ERROR --
20
WAITING (BATT.)
21
WAITING (HEAD)
22
WAITING (MOTOR)
23
BT INIT ERROR
24
BT SETTING ERROR
25
CHARGE ERROR $
26
Ir PACKET ERROR
27
Display of error
28
command
(See NOTE 1.)
Printer Status
Saving failed because of insufficient space in the
flash memory.
A back-up EEPROM cannot be read/written
properly.
The battery voltage has dropped to 7.2V or less for
B-EP2DL, or 14V or less for B-EP4DL.
An ambient temperature has dropped to -20 °C or
lower, or exceeded 60 °C.
The battery may be heated and hurt operators.
Please be careful not to get burned.
The battery may be heated and hurt operators.
System error
(a) A command has been fetched from an odd
address.
(b) Word data has been accessed from a place
other than the boundary of the word data.
(c) Long word data has been accessed from a
place other than the boundary of the long word
data.
(d) The logical area ranging from 80000000H to
FFFFFFFFH has been accessed in user mode.
(e) An undefined command in a place other than
the delay slot has been decoded.
(f) An undefined command in the delay slot has
been decoded.
(g) A command which rewrites the data in the
delay slot has been decoded.
The battery protection function is active.
The print head protection function is active.
The motor protection function is active.
The initialization of Bluetooth failed.
There is an error in the Bluetooth setting.
An error occurred while the battery was recharged.
A block number error occurred in the TEC protocol.
A command error has been found in analyzing the
command.
11-11
CHAPTER 11 OTHER FUNCTIONS
B-EP Series
Detail Status
Auto Status Status Request
Transmission Command
0EH 0EH
"54" "54"
0AH 0AH
"36" "36"
19H 19H
"19" "19"
32H 32H
"32" "32"
33H 33H
"33" "33"
45H
"45"
46H
"46"
47H
"47"
39H
"39"
39H
"39"
37H 37H
"37" "37"
02H 02H
"06" "06"
02H 02H
"06" "06"