Label Issue Operation - Toshiba B-EP Series Interface Specification

4.2.2

LABEL ISSUE OPERATION

An example of the label issue operation is described below.
(1) Where the Saved Data Read Command is not used:
After linking to each interface
Mode Select Command
Label Size Set Command
Position Fine Adjust Command
Print Density Fine
Image Buffer Clear Command
Line Format Command
Bit Map Font Format Command
Outline Font Format Command
Barcode/2-D Code Format Command
Bit Map Font Data Command
Outline Font Data Command
Barcode/2-D Code Data Command
Yes
<Change data issue>
Yes
<Format change>
Yes
NOTES: (1) The Label Size Set Command must be sent.
(2) After the power is turned off then on, the Bit Map Font Format Command, the
Power ON or
Place paper
Adjust Command
Feed Command
Issue Command
No
No
<Label change>
No
Power OFF
Outline Font Format Command, and the Barcode/Two-dimensional Code Format
Command should be sent as the occasion arises, because they are not protected
in memory.
CHAPTER 4 TRANSMISSION SEQUENCE
[ESC] M: Changes the print mode.
[ESC] D: Sets the label size.
[ESC] AX: Adjusts the feed length.
[ESC] AY: Adjusts the print density/separation setting.
[ESC] T: Feeds one sheet of paper and aligns it
with the first print position.
[ESC] C: Clears the image buffer.
[ESC] LC: Sets the line format and draws it.
[ESC] PC: Sets the bit map font format.
[ESC] PV: Sets the outline font format.
[ESC] XB: Sets the barcode/2-D code format.
[ESC] RC: Draws bit map font data.
[ESC] RV: Draws outline font data.
[ESC] RB: Draws barcode/2-D code data.
[ESC] XS: Issues (prints) the label.
4-4
B-EP Series