Toshiba B-EP Series Interface Specification page 497

7.5.13 HORIZONTAL OFFSET POSITION COMMAND
Function Sets the left margin (space from the left edge) of only the line.
Format [ESC] Oabbb
[ESC] Ocadddd
Initial value abbb: +000
Term a:
bbb: No. of offset dots from the position specified by [ESC] H (Fixed at 3 digits)
Explanation (1) When "a" or "bbb" is set to any value other than the above range, a command error
occurs.
(2) If other data is received after the horizontal offset position is specified again by this
command even though the data has already been drawn on the line, it is printed at
the position specified by this command. Therefore, it is printed over the already
drawn data.
(3) This command is effective until a line feed is performed. After a line feed is
performed, printing is performed at the print start position specified by the
Horizontal Print Position Command ([ESC] H).
(4) If the print start position specified by this command is on the right of the right end of
the print width specified by the Print Width Command ([ESC] W), a command error
occurs.
(5) If the print start position specified by this command is on the left of the print start
position specified by the Horizontal Print Position Command ([ESC] H), or the left
edge of the paper, a command error occurs.
Indicates whether the number of offset dots is increased or decreased
+: Increased
-: Decreased
-383 to +383
-831 to +831
CHAPTER 7 RECEIPT MODE (INTERFACE COMMANDS)
[ESC] O
B-EP2DL-GHxx
B-EP4DL-GHxx
7-28
B-EP Series