Toshiba B-EP Series Interface Specification page 101

LABEL mode (Issue)
Request for a Bluetooth
connection
Status request command
(Usually, a status request
command is not necessary to be
sent. However, send this
command when the printer status
is required to be confirmed prior to
a data transmission.) +C25
One of the following
commands:
- [ESC]FM[LF][NUL]
- [ESC]WS[LF][NUL]
- [ESC]v
Data print command
[ESC]X01H01H01H
[LF][NUL]
01H: Transmissive sensor
11H: Reflective sensor
21H: No sensor
Note: Automatic status
transmission is enabled.
A status request
command does not
need to be sent.
Repeat when there is a
next print job.
Request for a disconnection
of the Bluetooth connection
Finish the data storage operation and
return to Main Menu or another screen.
* The printer status can also be confirmed with the following command:
• [ESC] WB [LF] [NUL]
Note that the contents of the status vary, which deserves special attention.
Host Printer
request command.
STX Printer ID Printer status Battery level
02H xxHxxH
storage
STX Printer ID Printer status Battery level
02H xxHxxH
the Bluetooth connection
3-70
Response to the request for a Bluetooth
connection
Status sent in response to the status
00H
Make sure that the printer is
in idle state.
Status indicating a normal termination of data
10H
Normal termination
Response to the request for the disconnection of
CHAPTER 3 INTERFACE
B-EP Series
Confirmation
of the printer
status prior
to data
storage
xxH
Issue
Waiting time
xxH
until the end
of a print job