Toshiba B-EP Series Interface Specification page 102

RECEIPT mode (Storing graphics)
Request for a Bluetooth
connection
Status request command
(Usually, a status request
command is not necessary to be
sent. However, send this
command when the printer status
is required to be confirmed prior to
a data transmission.)
One of the following
commands:
- [ESC]FM[LF][NUL]
- [ESC]WS[LF][NUL]
- [ESC]v
Graphic command
[ESC]SG; . . . [LF][NUL]
Repeat when there is a
next print job.
Request for a disconnection
of the Bluetooth connection
Finish the data storage operation and
return to Main Menu or another screen.
* The printer status can also be confirmed with the following command:
• [ESC] WB [LF] [NUL]
Note that the contents of the status vary, which deserves special attention.
Host Printer
request command.
the Bluetooth connection
3-71
Response to the request for a Bluetooth
connection
Status sent in response to the status
STX Printer ID Printer status Battery level
02H xxHxxH 00H
Make sure that the printer
is in idle state.
Status indicating a normal termination of data
storage (when an automatic status transmission is
enabled.)
STX Printer ID Printer status Battery level
02H xxHxxH 10H
Normal termination
Response to the request for the disconnection of
CHAPTER 3 INTERFACE
B-EP Series
Confirmation
of the printer
status prior
to data
storage
xxH
Data
storage
xxH