Toshiba B-EP Series Interface Specification page 227

External equipment interface specification

Hide thumbs Also See for B-EP Series:

Table of Contents

Increment/decrement

Printing is performed while the data is incremented or decremented every time a label is

issued. Where the data row exceeds the maximum number of digits (40), the data row

will not be drawn.

Initial value

Zero suppression

Letters and numerals for increment/decrement

For the data string, up to 40 digits (including letters, numerals, and symbols) are

possible. Only the numerals are selected and calculated for incrementing/

decrementing, and then are returned to the previous position to draw the data.

Example of increment/decrement calculation

Initial value

(10) Zero suppression

No. of digits after zero

Zero(s) in a data row is replaced with a space(s) from the upper digits, according to the

designated number of digits. However, if the number of digits after zero suppression is

greater than the data row, the data row will be drawn without performing zero suppression.

Where the data row exceeds the maximum number of digits (40), the data row will not be

(11) Alignment

If characters are not placed on one line when justification is designated, the width is

calculated automatically. When the width is less than the limit value (2 mm) for the

outline font, that field will not be drawn. (The same previous field will not be drawn.)

CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)

Character string length in the

X direction (in 0.1 mm units)

Show Quick Links

Table of Contents