Toshiba B-EP Series Interface Specification page 428

Ciiijjj: No. of cells (Omissible. If this parameter is omitted, it is automatically set.)
iii: No. of cells in the X direction
jjj: No. of cells in the Y direction
NOTE: Cell setting varies according to the ECC type.
No. of cells to be
designated
Min./Max. No. of cells
Rectangular code
• When this parameter is omitted, the number of cells is automatically set.
Also, when data except for the above values is designated for Nos. of cells in
the X and Y directions, the number of cells is automatically set.
Jkkllmmmnnn: Connection setting
(Omissible: No connection if this parameter is omitted)
kk:
ll:
mmm: ID number
nnn:
NOTE: It is effective only when ECC200 is selected.
ooo: Data length
000 to 100
NOTES: 1. A two-digit value (00 to 99) is also available.
2. When "00" is designated, the length is equivalent to the data
3. When "00" is designated, the length is equivalent to the data
p: Data code
1 (Fixed value): JIS8 code
q: Reserved area
0: Fixed value
CHAPTER 6 LABEL MODE (INTERFACE COMMANDS)
000 to 144
000 to 144
ECC000 to ECC140
Odd numbers only
9 × 9 to 49 × 49
None
Code number
No. of divided codes
ID number 2
sent by the Data Print Command (data which is delimited by
[LF].)
sent by the Data Print Command. It corresponds for up to
2000 digits.
6-47
Even numbers only
10 × 10 to 144 × 144
18 × 8
32 × 8
26 × 12
36 × 12
36 × 16
48 × 16
01 to 16
01 to 16
001 to 254
001 to 254
B-EP Series
ECC200