Toshiba B-EP Series Interface Specification page 306

5.6.11 TWO-DIMENSIONAL CODE FORMAT COMMAND (MaxiCode)
Format [ESC] XBaa; bbbb, cccc, d (, e) (, Jffgg) (, Zh) (= mmm ------ mmm) [LF] [NUL]
[ESC] XBaa; bbbb, cccc, d (, e) (, Jffgg) (, Zh) (; nn
Term aa:
bbbb:
cccc:
d:
e:
Jffgg:
Two-dimensional code number
00 to 31
X-coordinate of the print origin of the two-dimensional code
Fixed at 4 digits (in 0.1 mm units)
Y-coordinate of the print origin of the two-dimensional code
4 or 5 digits (in 0.1 mm units)
Type of two-dimensional code
Z: MaxiCode
Mode selection (Omissible)
• When the MaxiCode specification is set to "TYPE1: Compatible with the
current version" in the SYSTEM mode.
Omitted: Mode 2
0: Mode 2
1: Mode 4
2: Mode 2
3: Mode 3
4: Mode 4
5: Mode 2
6: Mode 6
7: Mode 2
8: Mode 2
9: Mode 2
• When the MaxiCode specification is set to "TYPE2: Special specification" in
the SYSTEM mode.
Omitted: Mode 2 or Mode 3(*)
0: Mode 2 or Mode 3(*)
1: Mode 4
2: Mode 2
3: Mode 3
4: Mode 4
5: Mode 2 or Mode 3 (*)
6: Mode 6
7: Mode 2 or Mode 3 (*)
8: Mode 2 or Mode 3 (*)
9: Mode 2 or Mode 3 (*)
*: Mode 2 or Mode 3 should be determined depending on the country
code of the data command. When the country code is 840, Mode 2
should be selected. For other codes than 840, Mode 3 should be
selected.
Connection setting (Omissible. If omitted, connection is not made.)
ff: Code number
gg: No. of divided codes
5-136
CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)
[ESC] XB
nn nn
1, 2, 3,
01 to 08
01 to 08
B-EP Series
------ , nn ) [LF] [NUL]
20