Toshiba B-EP Series Interface Specification page 457

Status in the compatible mode for B-SP series
00H: Normal state (idling)
01H: Cover open state
02H: Command syntax error (including Ir packet error)
03H: Paper jam
04H: Label end
05H: Cover open error
06H: Broken thermal head dots error
07H: Thermal head excessive temperature
08H: Flash ROM write error
09H: Flash ROM erase error
0AH: Low battery (Print failure)
0BH: Printer operating
0DH: Normal end + Label end (See NOTE.)
0EH: Flash ROM storage area full state
(10H: Normal issue end):
37H: Charging error
39H: Bluetooth setup error (including initialization error)
NOTE:
Battery status ........ The battery charge status is indicated in 5 levels.
(B-EP2DL)
01H: 7.2 V or less (Print failure)
02H: 7.3 V to 7.4 V
03H: 7.5 V to 7.7 V
04H: 7.8 V to 7.9 V
05H: 8.0 V to 8.4 V
CHAPTER 6 LABEL MODE (INTERFACE COMMANDS)
including ambient temperature error, abnormal battery
temperature and battery excessive temperature
including the following statuses: wait for strip, pause
state, writable character/PC command save mode, wait
for battery recovery and wait for print head/motor
temperature reduction
Response status for automatic status transmission
This is a state when the printer runs out of labels, after
the effective print length is printed.
(Remaining No. of printable labels: Approx. 1 to 30)
(Remaining No. of printable labels: Approx. 30 to 150)
(Remaining No. of printable labels: Approx. 150 to 300)
(Remaining No. of printable labels: Approx. 300 min.)
6-76
B-EP Series