Toshiba B-EP Series Interface Specification page 172

[Reference] Flowchart for determining whether to perform a back feed and the stop position (Batch issue)
A
(*2): Whether to perform a back feed or not is determined depending on the combination of Conditions
2 and 3.
<Condition 2>
Label pitch
Less than 20.0mm
20mm or above, but less than 24.0mm,
and
Effective print length: Less than 15.0mm
20mm or above, but less than 24.0mm,
and
Effective print length: 15.0mm or above
24.0mm or above
Label pitch set for FEED key and Feed
command: 11.5mm or less
Label pitch set for FEED key and Feed
command: Over 11.5mm
Confirmation of
printer conditions
<Condition 1>
Sensor setting
by command
Sensor is
specified.
<Conditions 2&3>
Conditions for
performing a back
feed (*2)
Performs a back
feed.
<Condition 4>
Print data within
9.3mm from a start of
printing
Present
Back feed: Yes
Stop position: Cut
Conditions for performing a back feed
Back feed restriction in the system mode
OFF (Performed.)
ON (Not performed.)
OFF (Performed.)
ON (Not performed.)
OFF (Performed.)
ON (Not performed.)
OFF (Performed.)
ON (Not performed.)
OFF (Performed.)
ON (Not performed.)
OFF (Performed.)
ON (Not performed.)
CHAPTER 5 TPCL MODE (INTERFACE COMMANDS)
Sensor is not
specified.
<Condition 3>
Back feed
ON: Performs no
back feed.
Performs no
back feed.
<Condition 5>
Stop position
setting
Cut position
None
Back feed: No
Stop position: Cut
<Condition 3>
5-2
B-EP Series
OFF: Performs a
back feed.
A
Print head position
Back feed: No
Stop position: Head
Back feed
Performed.
Not performed.
Performed.
Not performed.
Performed.
Performed.
Performed.
Performed.
Performed.
Performed.
Not performed.
Not performed.