Toshiba B-EP Series Interface Specification page 691

LCD Messages of
Upper line
No.
(English)
20 SYSTEM ERROR --
21 WAITING (BATT.)
22 WAITING (HEAD)
23 WAITING (MOTOR)
24 BT INIT ERROR
25 BT SETTING ERROR
26 CHARGE ERROR $
Ir PACKET ERROR
27
28
Display of error
command
(See NOTE 1.)
29 BT Initializing
30 SSP AUTH FAILED
* When the compatible mode for the B-SP series is enabled, No.11 SAVING #### &&&& displays "ON
LINE."
* No. 30: "SSP AUTH FAILED" is displayed only when the printer model is B-EP-GH32 and SSP
authentication type is set to "Display Only" or "Display Yes/No" of Numeric Comparison.
LED
Indication
STATUS
System error
(a) A command has been fetched from
an odd address.
(b) Word data has been accessed from
a place other than the boundary of
the word data.
(c) Long word data has been accessed
from a place other than the boundary
of the long word data.
(d) The logical area ranging from
80000000H to FFFFFFFFH has
been accessed in user mode.
(e) An undefined command in a place
other than the delay slot has been
decoded.
(f) An undefined command in the delay
slot has been decoded.
(g) A command which rewrites the data
in the delay slot has been decoded.
The battery protection function is active.
The print head protection function is
active.
The motor protection function is active.
The initialization of Bluetooth failed.
There is an error in the Bluetooth setting.
An error occurred while the battery was
recharged.
A block number error occurred in the TEC
protocol.
A command error has been found in
analyzing the command.
BD address and bonding information are
being registered.
Bluetooth pairing failed. (This
message is displayed when SSP
authentication is rejected by the
host.)
11-17
CHAPTER 11 OTHER FUNCTIONS
Printer Status
B-EP Series
Restoration Acceptance
by the of Status
[PAUSE] Request and
key Reset
Yes/No Commands
Yes/No
No No
- Yes
- Yes
- Yes
No Yes
No Yes
No Yes
Yes Yes
Yes Yes
No No
Yes Yes