Toshiba B-EP Series Interface Specification page 212

External equipment interface specification

Hide thumbs Also See for B-EP Series:

Table of Contents

(10) Increment/decrement

Printing is performed while the data is incremented or decremented every time a label is

issued. Where the data row exceeds the maximum number of digits (40), the data row

will not be drawn.

When the font type is U, V, r, s, w, a (for JA type only), 41, 42, 43 or 51, increment/

decrement cannot be designated.

(Even if it is designated, it is ignored.)

Initial value

Zero suppression

Letters and numerals for increment/decrement

For the data string, up to 40 digits (including letters, numerals, and symbols) are

incrementing/decrementing, and then are returned to the previous position to draw the

Example of increment/decrement calculation

Initial value

(11) Zero suppression

No. of digits after zero

Zero(s) in a data row is replaced with a space(s) from the upper digits, according to the

designated number of digits. However, if the number of digits after zero suppression is

greater than the data row, the data row will be drawn without performing zero suppression.

Where the data row exceeds the maximum number of digits (40), the data row will not be

When the font type is U, V, r, s w, a (for JA type only), 41, 42, 43 or 51, zero suppression is

not designated.

(Even if it is designated, it is ignored.)

CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)

Show Quick Links

Table of Contents