Deleting A Projector; Creating A Multi-Function Project; Creating An Edge Blend Project; Saving Current Settings - Christie H Series User Manual

Deleting a projector

If a projector is no longer required, delete it.
1. In the Channel Network area, select a projector.
2. On the keyboard, select Delete.
The selected projector is deleted.

Creating a multi-function project

Create a new multi-function project for a single or multiple projectors.
1. To create a new project, select File > New Multi-Function.
2. Modify the projector profile, blending, and warping for each projector.
3. Save the file.

Creating an edge blend project

Use blending to increase or decrease the borders of an individual image, so it blends with a
neighboring image to create a single, seamless image.
1. Select File > New Blending.
2. Select the resolution of the projectors.
All projectors must have the same resolution.
3. Select Next.
4. Select the layout from the list.
5. Define the horizontal and vertical overlapping area with the slider bars.
6. Select Next.
7. Select the number ID of the projector and set the IP address for the projector.
8. Select Apply.
9. Repeat step 7 and 8 for each projector in the layout.
10. Select OK.
After the settings are applied, the general information is updated and Edge Blending is
enabled.
11. Configure the edge blending.
12. Save the file.

Saving current settings

Save your settings once you have them configured.
1. Make any adjustments required for warping, edge blending, or black leveling, or modify the
general settings.
2. From the File menu, select Save.
H Series, HS Series, GS Series and Inspire Series User Guide–Warping and Blending
020-000807-03 Rev. 1 (01-2024)
Copyright © 2024 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Warping and blending
8