Replacing Fan 6; Replacing Fans 4 And 10 - Christie GS Series Service Manual

Replacing fan 6

The fan 6 provides air cooling for phosphor wheel assemblies in the cooling module.
1. Remove the top cover.
See Removing the top cover
2. Remove the main board and I/O board.
See Replacing the main board and I/O board
3. Remove the rear cover.
See Removing the rear cover
4. Remove the front cover.
See Removing the front cover
5. Remove the left side cover.
See Removing the left-side cover
6. Remove the four M3 screws with a Phillips #1 screwdriver securing fan 6.
7. Replace fan 6.
8. To re-install, follow these steps in reverse order.

Replacing fans 4 and 10

The fans 4 and 10 provides the intake air cooling for the DMD assemblies in the light engine and the
red laser driver bank.
1. Remove all covers from the projector.
See Removing the top cover
front cover on page 65,
side cover on page 66.
GS Series 1075 Service Manual
020-001236-02 Rev. 1 (12-2019)
on page 63.
on page 64.
on page 65.
on page 66.
on page 63, Removing the rear cover
Removing the right-side cover
on page 83.
on page 64,
on page 65, and
Ventilation and cooling
Removing the
Removing the left-
72