Setting a fan speed profile
Use the fan speed profile to balance noise compared to brightness depending on projection needs.
1. Select MENU > System Settings > Fan Speed Profile.
2. Select the appropriate fan speed profile:
•
Standard—The projector attempts to achieve a balance between low noise and brightness
performance by adjusting fan speed with regards to ambient temperature and requested
brightness. (Default)
•
Quiet—The projector achieves the lowest noise at the possible expense of brightness
performance.
3. Select Enter.
Configuring video input
Defines which video inputs are available. This setting is persistent so when the projector powers up, it
loads the video input defined below.
When changing the selection, the system takes up to 15 seconds to re-configure. During this time the
user interface is not responsive.
1. Select MENU > Configuration > Input Settings > Video Input Configuration.
2. Select the appropriate video input configuration:
•
Default—Support HDMI, DP, SDI, HDBaseT, and ChristieLink. (Default)
•
SDVoE—Supports HDMI, SDVOE, HDBaseT, and ChristieLink.
3. Select Enter.
Informing the source of signal preferences
Configure Christie TruLife+ to automatically inform the video source of the preferred signal formats.
1. If you need a specific frame rate, from the display panel, select MENU > Configuration >
Input Settings > EDID Timing.
2. Select the required EDID timing and select Enter.
60 Hz is the default EDID timing.
Enabling or disabling the high frame rate (HFR)
If the high frame rate (HFR) mode is enabled, the projector can only operate in 2K output resolution.
To use 4K resolution, disable this mode.
This option is only available when the HFR license is installed and the projector is in standby mode.
1. Select MENU > Configuration > Input Settings > High Frame Rate.
2. To change to 2K resolution for HFR, select Enable.
Christie TruLife+ User Guide
020-103315-01 Rev. 1 (09-2020)
Copyright
©
2020 Christie Digital Systems USA, Inc. All rights reserved.
Configuring system settings
36