Configure The Display; Output Options - Christie Mirage WQ-L User Manual

Gamma Function
Defines the base gamma power curve used when Gamma is set to Gamma Function. This value,
combined with the Gamma Slope setting determines the base Gamma table to be used as the custom
base table. The curve is generally a power curve with a small linear segment at the bottom defined by
the slope.
Gamma Slope
This control defines a slope to be used for the base custom Gamma table for a small section at the
bottom of the curve. This slope can be used to bring in or out the low level blacks in the image. This
slope, combined with the gamma function, defines the custom Gamma table.

Configure the Display

The Configuration menu provides access to diagnostics, calibration tools and the Service submenu
(password-protected). Use this menu to define general operating parameters and communications
with other projectors and equipment, and to access other advanced processing and image
adjustments affecting overall performance. To access this menu select Configuration from the
Main menu.

Output Options

Change Screen Image Orientation
1. From the Main menu, select Configuration > Output Options.
2. From the Screen Image Orientation drop-down select from front, rear, front inverted, and
rear inverted.
Control Frame Locking
Use frame locking to select how the projector controls the output frame timing based on the input
signal.
Frame locking on projectors in a ArrayLOC network can be controlled from one projector. 
See
1. From the Main menu, select Configuration > Output Options.
2. From the Frame Locking drop-down menu select Frame Lock to lock output image frames to
the primary input or select Frame Lock Secondary to lock output images to the secondary
input.
Set Frame Delay
This control delays the output signal timing relative to the input signal timing by a fraction of a
frame. In a multi-projector system this control may be used to adjust the output timing relative to
the input so that all the projectors display the image at the same time. This allows for a seamless
display across projectors.
Mirage WQ-L User Manual
020-101372-01 Rev. 1 (04-2014)
Configure the Display on page 48.
Operation
48