Display Panel Components; Workflow: Installing And Setting Up The Mirage Sst System - Christie Mirage SST Installation And Setup Manual

Display panel components

Identify the main components of the display panel (also known as the home page).
ID Component
A Projector information
B Projector and Component
Controls
C Power and Temperature
D Status
E IP Settings
F Test Pattern
G Input
Workflow: Installing and setting up the Mirage
SST system
Identify the recommended order for installing and setting up the components of the Mirage SST
system.
These tasks detail the steps for installing both single (3P) and dual (6P) systems. For the dual system,
repeat the tasks for both the left-eye and right-eye systems, making sure you connect the correct
light source to the correct projector head.
Mirage SST Installation and Setup Guide
020-102956-08 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Description
Provides information about the projector such as the projector
name, serial number, software version, and projector ID.
Indicates the states of the projector and its components.
Indicates the light source mode, power mode, and intake
temperature.
Contains information about the health of the projector including
the number of warnings and errors.
Provides access to the status system.
Indicates the incoming voltage, measured in Volts, and intake
temperature, measured in Celsius.
Displays the currently selected test pattern. If no test pattern is
selected, Off is displayed.
Provides access to the list of test patterns.
Displays the signal for the currently selected input.
Provides access to the list of input signals.
Installation and setup
24