Adjust Image Geometry Using The Projector Software; Adjust Black Levels And Input Drives; Adjust Color Using Arrayloc - Christie Entero RPMSP–LED01 Installation Manual

For information about managing channels, see the Entero RPMWU/RPMSP/RPMHD–LED01 User Manual
(P/N: 020-100367-xx).

4.6.2 Adjust Image Geometry Using the Projector Software

Only use projector software options if the images still requires adjusting after the hardware has been optimized
and Auto Setup has been run. See the Entero RPMWU–RPMSP–RPMHD–LED01 User Manual (P/N: 020-
100367-xx) for details about software based geometry changes: Size and Position, Resize Presets, Geometry
Correction.

4.6.3 Adjust Black Levels and Input Drives

For analog sources, optimize input levels.
1. Display the source image. The image must have at least 3 adjacent black and 3 adjacent white pixels. For
best results, display a 16–step grayscale pattern.
2. Select Main Menu > Image Settings > Input Levels.
3. Select Auto Input Levels.
4. When the values for black levels and input drives start to stabilize, clear Auto Input Levels.
5. Exit the projector menus.
NOTE: To adjust input drives and black levels manually, set black levels for all colors at full black. Set drive
levels at 60–70% white.
4.7

Adjust Color Using ArrayLOC

Use projector color adjustments to match the color primaries for all the
projectors in the array.
This procedure requires that the projectors are wired for ArrayLOC. See
Connect Projectors for ArrayLOC, on page
1. Select Main Menu > Configuration > ArrayLOC > Array Color
Target.
2. Set Target Color Space to User 1.
3. Check that Copy Color Space From is set to Maximum.
4. Check that Select White Point is set to 6500 (D65).
5. Select 1 projector to work with and select Main Menu > Configuration > ArrayLOC > Synchronize to
This Projector.
6. Adjust colors for each projector in the array to calibrate the array as a system.
a. Select Main Menu > Configuration > ArrayLOC > Projector Color Adjustment.
b. Set Target Color Space to User 1
c. Use White Brightness Adjustment to match the brightness on all the projectors in the array.
d. Use the color settings (red part/green part/blue part) to adjust the color primaries to match across all
projectors.
• You may need to add some green to some of the reds.
• Greens are usually pretty consistent.
4-10
3-13.
3.7
Entero Projector and Cube Installation Manual
020-100839-01 Rev. 2 (04-2013)