Extra Video; Optional Inputs; Connecting The Ballast - Christie Roadie HD+35K Setup Manual

2.5.5 Extra Video

If you want to use an extra video source in
addition to the video source(s) connected at
INPUT 3 or INPUT 4 connect either a
Composite or S-video source to INPUT 1 as
shown.
NOTES: 1) Do not simultaneously connect
Composite and S-video to INPUT 1. 2) You can
switch between video sources connected at
INPUT 1 and INPUT 3 or INPUT 4.

2.5.6 Optional Inputs

Optional input modules allow you to increase
your total number of inputs and/or accommodate
different signal types, whether analog or digital.
Install in the areas labeled INPUT 6 or (if
available) INPUT 5. These interfaces include:
• DVI Input Module
• Dual SD/HD-SDI Module (supplied as
standard in this projector)
For even more sources, connect a third-party
switcher to the RS-232 IN port, or, if RS-422-
compatible, to any of the two RS-422 ports.
Older input cards not listed may be supported by
the Roadie HD+35K.
NOTES: 1) Connect analog HDTV signals
directly to INPUT 1 or to any other "RBG" input module installed-the optional HDTV Input Module used in
earlier projectors is not needed or recommended. 2) See Appendix D: Optional Input Modules in the Roadie
HD+35K User Manual for a brief description of each interface.
2.6

Connecting the Ballast

Do not connect the ballast to AC until the projection head and ballast are connected to each other.
Roadie HD+35K Setup Guide
020-100394-06 Rev. 1 (10-2013)
Connect the ballast to the projector FIRST, then connect the ballast to AC.
Section 2: Installation and Setup
Figure 2-14 Connect Extra Video
2-21