Cleaning Blade Pressure/Retraction Failure - Xerox Phaser 6115MFP Service Manual

15H Cleaning Blade Pressure/Retraction Failure
Phaser 6115MFP Multifunction Product Service Manual
Troubleshooting Procedure Table
Step Action and Questions
Check the Main Motor connector P/J8 to
1
the Engine Control Board. Is the
connection seated properly?
2 Check the Main Motor for proper drive
operation.
Is the motor operational?
3 Check the Cleaning Blade solenoid. Is it
operational?
Replace the Engine Control Board
4
(page 8-57).
Does the problem persist?
Check the 2nd Image Sensor connector
5
P/J11 to the Engine Control Board. Does
the problem persist?
Faulty sensor, solenoid, or cleaning blade retraction.
Applicable Status Code
15H:

Cleaning Blade Pressure/Retraction Failure

Initial Actions
Remove power from the system and reboot.
Print a test page.
Error Codes and Messages
Yes No
Go to Step 2. Reseat the
connector and
go to Step 2.
Go to Step 3. Replace the
motor
(page 8-93).
Go to Step 4. Replace the
solenoid
(page 8-105). If
the problem
persists, go to
Step 4.
Go to Step 5. Complete
Replace the Complete
transfer Belt
Unit
(page 8-33).
3-19