Table of Contents
Advertisement
Hardware Manual
How to Cable Components Added to Existing Frames
To cable equipment added to an existing frame, follow the directions in one of the following
sections:
How to Cable a T1100 AS Unit Added to an Existing Heavy Duty Frame
How to Cable a T1100 AS Installed in Customer-Provided Frame
How to Cable a T1100 AS Unit Added to an Existing Heavy Duty Frame
WARNING: Verify that all breakers are set to the OFF (O) position.
In a Direct Current (DC) environment, after an additional T1100 AS unit has been installed, attach
cables.
To determine the cables used and how to connect them, refer to the
lists each cable, its quantity, length, how it is used, and a diagram of how to connect it.
Note: Some of the listed cables are used only as required. Actual cables used may vary by
application.
To view a drawing of a cable, refer to the
in the system interconnect diagram with a link from each part number to the drawing for that part
number.
How to Cable a T1100 AS Installed in Customer-Provided Frame
WARNING: Verify that all breakers are set to the OFF (O) position, and that all
power distribution unit switches are in the OFF position.
In an Alternating Current (AC) environment, after the T1100 AS unit has been installed, attach
cables.
To determine the cables used and how to connect them, refer to the
lists each cable, its quantity, length, how it is used, and a diagram of how to connect it.
Note: Some of the listed cables are used only as required. Actual cables used may vary by
application.
910-2969-001 Revision K, June 2009
How to Install Hardware in an Existing Frame
interconnect
diagram, which lists all the cables that appear
on page 81
on page 81
interconnect
diagram, which
interconnect
diagram, which
81
Advertisement
Table of Contents
