Table of Contents
Advertisement
About This Manual
1. Request that the Customer Care Center assist you in determining whether the hard disk drive
assembly that needs to be replaced is in position "A" or position "B".
2. Determine whether the required Hard Disk area (A or B) of the base unit/hard disk label on
the front of the left side of theT1100 AS chassis can be viewed from the side of the frame without
sliding the chassis out from the frame.
See
Figure 8: T1100 AS Chassis Label Locations
chassis and
Figure 9: Base Unit/Hard Disk Label onT1100 AS Chassis
of the Hard Disk information on the label.
3. If the necessary Hard Disk area of the base unit/hard disk label shown in
Disk Label onT1100 AS Chassis
from the label, and skip to
Otherwise, perform the remaining steps.
WARNING: Always wear an ESD wrist strap grounded to the bench or frame
when working on electronic components.
4. You do not need to slide the chassis from the frame to examine the hard drive labels.
From the front of the frame, unscrew the knurled screws on the sides of the chassis and unlock
the front pane (see
Figure 10: T1100 AS front fascia open with hard drive locations
20
on page 19 can be viewed, report the requested information
Step 7
on page 21.
Figure 1: T1100 AS Chassis Front View
on page 19 for the placement of the label on the
on page 19 for the location
on page 15).
910-2969-001 Revision K, June 2009
Hardware Manual
Figure 9: Base Unit/Hard
Advertisement
Table of Contents
