Table of Contents
Advertisement
Hardware Manual
labels on the right of the chassis as seen from the rear. See
on page 112.
8. Loosen the screws that attach the chassis retention brackets to the T1100 AS chassis.
The chassis retention brackets are adjusted in
Assembly Mounting and Retention Bracket
9. From the front of the frame, simultaneously press the round release buttons and slowly push
the chassis into the frame while observing the cables to avoid binding or stretching.
Note: When the chassis stops moving, the front of the T1100 AS should be slightly recessed
to allow clearance behind the frame door when closed.
10. Adjust the chassis retention brackets on the front of the T1100 AS chassis to contact the frame
adapter brackets when the chassis is positioned correctly in the frame.
11. Tighten the screws that attach the chassis retention brackets to the T1100 AS chassis.
12. Secure the chassis with one # 12-24 screw in the chassis retention brackets on each side.
13. Replace any plastic panels and doors that were removed.
14. This procedure is complete.
Next, turn the power back on as described in
How to ReplaceT1100 AS FRUs
Use one of the following procedures in this section to replace aT1100 AS FRU:
1.
How to Replace the Air Filters
2.
How to Replace the Square Fan Assembly
3.
How to Replace Hard Disk Drive Assemblies
4.
How to Replace Removable Media Disk Drives (CD/DVD)
5.
How to Replace PCI Cards
6.
How to Replace aT1100 AS Chassis FRU
How to Replace the Air Filters
There are two air filters on theT1100 AS: the rectangular air filter and the square air filter. It is
recommended that the air filters on theT1100 AS chassis be replaced at least once a month. Before
beginning these procedures, ensure that spare filters are on hand. If the number of spare filters is
running low, order additional filters.
This section has not yet been updated.
Note: It is not necessary to slide out or remove theT1100 AS chassis from its frame in order to
replace the filter.
show me: To view a video (with sound) that shows some steps of the following
procedure,
to read all the steps in the following procedure. For more information about how to
view this video, see
910-2969-001 Revision K, June 2009
on page 111 for screw locations.
on page 113
on page 116
on page 118
on page 129
on page 134
click
here. For personnel safety and to protect equipment and data, be sure
Programs Needed to View Linked Documents
Figure 65: T1100 AS Chassis Rear View
Step 11
on page 113. See
How to Power Up
on page 96 .
on page 123
Field Replaceable Units
Figure 64: Right Slide
on page 4.
113
Advertisement
Table of Contents
