Figure 14: T1100 As Chassis Front View - Tekelec 1100 Hardware Manual

Hardware Manual
WARNING: Always wear an ESD wrist strap grounded to the bench or frame
when working on electronic components.
4. From the front of the frame, remove the # 12-24 Phillips screw from each chassis retention
bracket (see Figure 1: T1100 AS Chassis Front View
Do not remove the screws in the frame adapter brackets.

Figure 14: T1100 AS Chassis Front View

5. From the front of the frame, using the knurled screws on the sides of the chassis, pull forward
until the release buttons on the inner arms of the slide assemblies pop into the holes on each
side.
Be careful you do not disconnect, bind, or pinch any cables.
DANGER: If theT1100 AS chassis is pulled too far out after the release buttons
are disengaged, the inner slide members (attached to the chassis) could come out
of the middle slide members (attached to the frame).
6. Report the requested part number
7. From the front of the frame, simultaneously press the round release buttons and slowly push
the chassis into the frame while observing the cables to avoid binding or stretching.
Note: When the chassis stops moving, the front of theT1100 AS should be slightly recessed to
allow clearance of the handles behind the frame door when closed.
8. Adjust the chassis retention brackets on the front of theT1100 AS chassis to contact the frame
adapter brackets when the chassis is positioned correctly in the frame.
9. Secure the chassis with one # 12-24 screw in the chassis retention brackets on each side.
10. This procedure is complete.
910-2969-001 Revision K, June 2009
on page 15).
information from the PCI slots label.
About This Manual
23