Table of Contents
Advertisement
Hardware Manual
5. Using a Phillips screwdriver, loosen the two screws on each side of the front top cover.
See
Figure 75: Front Top Cover Removal - Screw Locations
Figure 75: Front Top Cover Removal - Screw Locations
6. Grasp the edge of the front top cover of the chassis and lift up to remove the cover.
7. To access the IDE cables of the drives, remove the top rear cover.
Unscrew the knurled screw at the back of the chassis. Slide the cover towards the rear of the
chassis and lift the cover off of the chassis.
8. You must remove both rectangular fans to access the CD/DVD drive bracket screw.
There are two rectangular fan assemblies on the right of the chassis. The removal instructions
are the same for each assembly. Grasp the top of each fan assembly with your index finger
underneath the left and right edges of the top of the fan assembly. Lift the fan assembly straight
up and out of the chassis to remove it.
910-2969-001 Revision K, June 2009
Field Replaceable Units
on page 125 for locations.
125
Advertisement
Table of Contents
