Figure 40: Anchoring Frame To Raised Floor With Support Channel - Tekelec 1100 Hardware Manual

How to Install aT1100 AS Frame
39: Anchor Assembly for Use with Support Channel
their orientation):
a) 5/8 inch nut
b) Small steel washer
c) Large steel washer
3. From underneath the raised floor, insert the threaded rod/anchor assembly through the support
channel, the raised floor, the isolator pad, and the frame floor.

Figure 40: Anchoring Frame to Raised Floor with Support Channel

4. From inside the frame, drop onto each threaded rod the following components in the order
shown (see Figure 40: Anchoring Frame to Raised Floor with Support Channel
a) Metal sleeve inside a nylon shoulder washer
b) Fiber washer (around the nylon shoulder washer)
c) Large steel washer
d) Small steel washer
e) Torque nut
Be sure to leave at least 5 threads of the threaded rod exposed inside the frame.
5. Finger tighten the nut above the raised floor before finger tightening the nuts below the raised
floor.
6. Finger tighten the nut below the raised floor.
7. Securely tighten all the nuts above the raised floor with a socket wrench.
Note: Tighten only until the washer and nuts are flush with the bottom of the floor tile. DO
NOT over tighten.
8. Replace tiles if necessary.
9. This procedure is complete.
64
on page 63 to identify the components and
910-2969-001 Revision K, June 2009
Hardware Manual
on page 64):