Figure 19: Pci Card Label Ont1100 As Chassis - Tekelec 1100 Hardware Manual

Hardware Manual
8. Supply all the information from the PCI slots label (see
Chassis on page 27) and report whether the replacement chassis is to also contain replacement
PCI cards.
The information for all slots is needed in either case:
a) If the replacement chassis is to contain replacement PCI cards as well, Tekelec manufacturing
will use the information to install the replacement PCI cards and also to create the new PCI
slots label and apply it to the replacement chassis
b) If the replacement chassis does not need to contain replacement PCI cards, Tekelec
manufacturing will use the information to create a new PCI slots label and apply it to the
replacement chassis

Figure 19: PCI Card Label onT1100 AS Chassis

9. If the chassis was not slid out, skip to
Otherwise, complete the remaining steps.
10. From the front of the frame, simultaneously press the round release buttons and slowly push
the chassis into the frame while observing the cables to avoid binding or stretching.
Note:
When the chassis stops moving, the front of theT1100 AS should be slightly recessed to allow
clearance of the handles behind the frame door when closed.
11. Adjust the chassis retention brackets on the front of theT1100 AS chassis to contact the frame
adapter brackets when the chassis is positioned correctly in the frame.
12. Secure the chassis with one # 12-24 screw in the chassis retention brackets on each side.
13. This procedure is complete.
910-2969-001 Revision K, June 2009
Figure 19: PCI Card Label onT1100 AS
Step 13
on page 27.
About This Manual
27