How To Change Passwords - Tekelec 1100 Hardware Manual

Hardware Manual
WARNING: Before powering up, verify that all output breakers or power distribution
unit switches are set to the OFF (O) position. Be sure the chassis power switch is set
to the OFF position.
1. Ensure that all AC and DC connections have been secured and checked.
2. Verify the ground at the AC outlet.
See How to Verify the Ground in an AC Environment
3. Set the output breakers to "ON" to send power to the T1100 AS unit.
4. Turn the T1100 AS chassis switch to "ON".
5. This procedure is complete.

How to Change Passwords

For security purposes, Tekelec recommends that all default passwords be changed to your own
passwords. The new passwords should be kept in a secure location.
To change the passwords for the T1100 AS platforms, refer to the application manual for the
application loaded on each server.
To change the passwords for the Ethernet switches, refer to the application manual for the
application loaded on each server.
Note: There should always be a person on-site who knows the new passwords. If there is a
need to contact the
910-2969-001 Revision K, June 2009
Customer Care Center on page 7, please provide the passwords on request.
Post Installation Procedures
on page 94.
97