Table of Contents
Advertisement
About This Manual
Be careful to not disconnect, bind, or pinch any cables.
DANGER: If theT1100 AS chassis is pulled too far out after the release buttons
are disengaged, the inner slide members (attached to the chassis) could come out
of the middle slide members (attached to the frame).
3. Using a Phillips screwdriver, loosen screws on theT1100 AS chassis front top cover until they
are free.
See
Figure 6: T1100 AS Front Top Cover screws
Figure 6: T1100 AS Front Top Cover screws
4. Lift the cover off of the chassis.
5.
Figure 7: CD/DVD label location
drive assembly part label.
Figure 7: CD/DVD label location
6. Close the chassis front top cover.
7. Tighten the screws to secure the front top cover.
8. From the front of the frame, simultaneously press the round release buttons and slowly push
the chassis into the frame while observing the cables to avoid binding or stretching.
Note: When the chassis stops moving, the front of theT1100 AS should be slightly recessed to
allow clearance behind the frame door when closed.
9. Adjust the chassis retention brackets on the front of theT1100 AS chassis to contact the frame
adapter brackets when the chassis is positioned correctly in the frame.
18
on page 18 for locations.
on page 18 shows the location of the removable media disk
Hardware Manual
910-2969-001 Revision K, June 2009
Advertisement
Table of Contents
