Figure 36: Anchor Installation Of Hd Frame Into Slab Floor - Tekelec 1100 Hardware Manual

Hardware Manual
7. Install the three square washers, the round fiberglass washer, the large steel washer, and the
torque nut (with red plastic cover) in the order shown in
Frame into Slab Floor
(The large steel washer, nylon shoulder washer, and round fiber washer are found in the
mounting hardware kit.) When reassembling the anchor assembly, the bottom of the threaded
rod must be flush with the bottom of the cone nut and the torque nut must be near the top of
the threaded rod.
Note: When reassembling any anchor bolt assembly, lightly finger tighten only.

Figure 36: Anchor Installation of HD Frame into Slab Floor

8. Tighten the top nut of the anchor assembly with a socket wrench until the twist off nut above
the plastic red cover breaks free.
Leave the twist off nut on the threaded rod to indicate that the torque on the nut beneath has
been set properly.
9. This procedure is complete.
910-2969-001 Revision K, June 2009
on page 59.
How to Install aT1100 AS Frame
Figure 36: Anchor Installation of HD
59