Figure 16: T1100 As Chassis Front View; Figure 17: Base Unit/Hard Disk Label Ont1100 As Chassis - Tekelec 1100 Hardware Manual

Hardware Manual
3. Determine whether the base unit/hard disk label, PCI slots label, and memory label on the
sides of theT1100 AS chassis can be viewed from the sides of the frame without moving the
chassis:
a) If all labels can be viewed, go to
b) If one or more labels cannot be viewed, go to the next step.
4. From the front of the frame, remove the # 12-24 Phillips screw from each chassis retention

Figure 16: T1100 AS Chassis Front View

bracket (see
Do not remove the screws in the frame adapter brackets.
Figure 16: T1100 AS Chassis Front View
5. From the front of the frame, using the knurled screws on the sides of the chassis, pull forward
until the release buttons on the inner arms of the slide assemblies pop into the holes on each
side.
DANGER:
If theT1100 AS chassis is pulled too far out after the release buttons are disengaged,
the inner slide members (attached to the chassis) could come out of the middle
slide members (attached to the frame).
6. Supply the requested part number information from the following areas of the base unit/hard
disk label

(Figure 17: Base Unit/Hard Disk Label onT1100 AS Chassis

view of the label):
Figure 17: Base Unit/Hard Disk Label onT1100 AS Chassis
910-2969-001 Revision K, June 2009
Step 6
WARNING:
Always wear an ESD wrist strap grounded to the bench or frame when working
on electronic components.
on page 25.
on page 25).
on page 25 shows an expanded
About This Manual
25