Introduction; How To Unpack And Conduct Inventory; How To Unpack A T1100 As Unit And Conduct Inventory - Tekelec 1100 Hardware Manual

How to Install Hardware in an Existing Frame

Introduction

This chapter describes how to unpack and install individual T1100 AS hardware system components
and install them in frames that are already installed at customer sites.
Note: Some of the figures in this section show the T1100 AS. The T1000 is identical in size to the
T1100 , and the frame installation instructions are the same for both chassis.
For information about installing a T1100 AS hardware system that is delivered in a frame, see
to Install aT1100 AS Frame

How to Unpack and Conduct Inventory

To unpack and conduct inventory, see one of the following sections:

How to Unpack a T1100 AS Unit and Conduct Inventory

How to Unpack a T1100 AS Unit and Conduct Inventory
When the individual T1100 AS unit arrives, perform the following procedure:
TOPPLE: Before beginning this procedure, ensure the frame is properly secured to the
floor and cable racks to prevent the frame from tipping over when the slide assembly
and T1100 AS chassis is extended.
DANGER: Moving a T1100 AS chassis requires two people. Each T1100 AS chassis
weighs approximately 30 kg (65 lbs) and may cause personnel injury or damage to
the internal components due to shock and vibration if not handled properly.
1. Inspect the shipping container for indication of damage.
If damage is noted, go to
2. Inventory the material in the shipping container.
If any discrepancies are noted, go to
WARNING: Observe proper ESD procedures when handling the T1100 AS
chassis. Always wear an ESD wrist strap connected to a grounded bench or frame.
3. Unpack the T1100 AS chassis from the shipping container and place the unit on a secure
workbench that is grounded for ESD protection.
Discard the container and packing material.
4. Inspect the T1100 AS chassis for indication of damage.
If damage is noted, go to
70
on page 53
Step 7
on page 71.
Step 7 on page 71.
Step 7 on page 71.
on page 70
Step 7 on page 71
910-2969-001 Revision K, June 2009
Hardware Manual
How