Figure 60: Frame And Logic Ground Cable Attachment Locations - Tekelec 1100 Hardware Manual

Hardware Manual
Note: This figure shows five servers in the frame. For more complete information about the
configuration used by the application, refer to the
3. Apply the 145C cable tag (see
page 91) to both ends of the logic ground cable. Also, apply the "Do Not Disconnect" tag to
both ends of the logic ground cable.

Figure 60: Frame and Logic Ground Cable Attachment Locations

Note: DO NOT run Logic Ground or Power Cables on the cable horns in the top middle of a
frame.
Note: The number of inter-frame Logic Ground connections may vary from the example shown
Figure 60: Frame and Logic Ground Cable Attachment Locations
in
connection per T1100 AS.)
4. This procedure is complete.
Next, go to How to Connect T1100 AS Logic Ground Port to Logic Ground Terminal Strip
910-2969-001 Revision K, June 2009
Assembly
Figure 60: Frame and Logic Ground Cable Attachment Locations
Post Installation Procedures
Drawing.
on page 91. (One logic ground
on page 92.
on
91