Figure 65: T1100 As Chassis Rear View - Tekelec 1100 Hardware Manual

Field Replaceable Units
5. Push the T1100 AS chassis toward the frame.
When the buttons encounter the middle slide members, simultaneously press the release buttons
on the inner slide members on both the left and right sides.
Note: The inner slide members will continue to travel until the release buttons pop into the
round holes of the middle slide members.
6. At the rear of the frame, do one of the following:
a) For Side Cable Management Arm Systems attach the side cable management arms to the
rear of the frame above the rails using the bolts provided (see
T1100 AS Unit

Figure 65: T1100 AS Chassis Rear View

7. Route and connect the power and data cables through the cable management system to the
T1100 AS chassis.
Check the labels on the cables and attach them to the appropriate connectors on the rear of the
T1100 AS chassis. Consult the cable running list, labels on the cables, and PCI configuration
112
on page 71).
Hardware Manual
How to Install an Individual
910-2969-001 Revision K, June 2009