Figure 69: Inside View Oft1100Showing Hard Drive Locations - Tekelec 1100 Hardware Manual

Field Replaceable Units
Note: If this procedure is being performed to move hard disk drives from a failedT1100 AS
chassis to a replacementT1100 AS chassis,
page 108 is recommended.
4. To replace the hard drives, first open the front fascia by unscrewing the knurled screws on
either side of the chassis, and use the key to unlock the front fascia.
Once unlocked, carefully swing the front fascia open from the top of the chassis. The two hard
drives are located below the rectangular fans. See
drive locations
CAUTION: Be sure you do not unplug the cable from the printed circuit board
behind the front fascia while opening the front fascia. Removing this cable from
its connections will cause the server to shut down.

Figure 69: Inside view ofT1100showing hard drive locations

5. Do one of the following:
a) If this procedure is being performed to replace a failed hard disk drive, skip to the next
step.
b) If this procedure is being performed to move hard disk drive assemblies from a failedT1100
AS chassis to the replacementT1100 AS chassis, note the position of the hard disk drive
assembly that is about to be removed.
The brackets on which the hard disk drives are mounted have position location labels. From
the front of the chassis, the "A" drive is on the left and the "B" drive is on the right. It is
recommended that this entire procedure be performed to remove the "A" hard disk drive
assembly from the failedT1100 AS chassis and replace it into the "A" position in the
replacement chassis, and then the procedure be repeated to remove the "B" hard disk drive
120
on page 120 for hard drive locations.
How to Remove T1100 AS Chassis from a Frame
Figure 69: Inside view ofT1100showing hard
910-2969-001 Revision K, June 2009
Hardware Manual
on