Table of Contents
Advertisement
Hardware Manual
12. Lift the T1100AS chassis with the attached inner slide members and carefully insert the inner
slide member rollers into the middle slide members that were previously mounted on the
frame.
13. Simultaneously press the release buttons on the inner slide members once when the buttons
encounter the middle slide members.
Note: The inner slide members will travel approximately two more inches and the release
buttons will detent into the round cutouts of the middle slide members. This is the standard
open position of the slides.
14. Attach the Cable Management System.
Do one of the following:
a) For Side Cable Management Systems, attach the cable management arms to the rear of the
frame using the bolts included with the system.
Be sure that the arms can slide in toward the T1100AS.
Figure 52: Detail of a Side Cable Management Arm
910-2969-001 Revision K, June 2009
How to Install Hardware in an Existing Frame
77
Advertisement
Table of Contents
