Table 6: Tekelec 1100 As Chassis Dimensions And Weight - Tekelec 1100 Hardware Manual

Hardware Manual
T1100 AS Chassis Installation and Replacement
TheT1100 AS chassis is installed in the frame using slides that have inner and outer rails. The outer
slide rail is attached to the frame and the inner slide rail is attached to theT1100 AS chassis (see
Figure 44: Slide Assembly
outer rails.
DANGER: Moving aT1100 AS chassis requires two people. EachT1100 AS chassis
weighs approximately 30 kg (65 lbs) and may cause personnel injury or damage to
the internal components due to shock and vibration if not handled properly.
The Tekelec 1100 AS chassis is also field replaceable. Tekelec 1100 AS replacement, including
disconnecting cables, mounting a replacement system (of identical configuration), and reconnecting
cables requires no more than 30 minutes.
Note: All I/O connections are at the rear of the Tekelec 1100 AS chassis.

Table 6: Tekelec 1100 AS Chassis Dimensions and Weight

1100 AS chassis.
Table 6: Tekelec 1100 AS Chassis Dimensions and Weight
Dimension
Depth
Height
Width
Weight
910-2969-001 Revision K, June 2009
on page 71). The chassis is installed by sliding the inner rails into the
Value
21.6 inches from front surface
to rear bulkhead
6.9 inch high (4U) form factor
17.6 inches wide, with slides
65 Pounds
T1100 AS Hardware System Overview
on page 45 lists the dimensions of the Tekelec
Notes for Rack-Mounting
Allows over 2.5 inches of depth
for cable management in a
Tekelec Heavy Duty Frame.
Chassis slide lock brackets are
used to anchor the Tekelec 1100
AS chassis in position during
normal operation.
Allows for multiple Tekelec
1100 AS chassis and associated
Ethernet switches to be
mounted in a Tekelec Heavy
Duty frame
Allows for a Tekelec 1100 AS
chassis to be installed in 19 inch
racks. Adapter plates are
required to mount a Tekelec
1100 AS chassis with slide rails
in 23 inch frames.
Moving the chassis requires
two people.
45