T1100 AS Hardware System Overview
Breaker Panel Settings
To view a graphic that shows the mapping of breakers to the devices, see BreakerSettings.pdf. When
a server is installed and powered up, the associated breakers should be closed. Inactive breakers
are not required to be in the closed position.
Note:
The breaker mapping table shows only end-to-end connectivity from the breaker panel breakers
to the servers. For detailed information on wiring, see the
Power Distribution Units
The AC Power Distribution Unit (PDU) is connected to a 240 V AC power source and distributes
power to the components of the LSMS frame. Power is distributed to A side and B side feeds.
There is one ON/OFF breaker switch for four A side power outlets and one ON/OFF breaker
switch for four B side power outlets. For more information about the PDU, refer to the
documentation that was delivered with the product.
Figure 33: Front and rear of AC power distribution unit
Ethernet Switches or Hubs
Ethernet switches or hubs cross-connect all the components in a heavy duty frame. To determine
which type of Ethernet switch or hub is used, see the
50
interconnect
diagram.
Assembly
drawing. For more information
910-2969-001 Revision K, June 2009
Hardware Manual