How to Install Hardware in an Existing Frame
16. From the front of the frame, press the round release buttons and slowly push the T1100AS into
the frame while observing the cables to avoid binding or stretching (see
Mounting Detail
Figure 55: Frame Mounting Detail
The chassis retention brackets on the front of the T1100AS will contact the frame adapters when
the chassis is positioned correctly in the frame.
17. Secure the chassis with one #10-32 screw on each side in the chassis retention brackets.
18. You must perform the procedures in before powering up the unit.
WARNING: Do not power up the unit at this time.
19. Replace any plastic panels and doors that were removed.
20. This procedure is complete.
80
on page 80).
Hardware Manual
Figure 55: Frame
910-2969-001 Revision K, June 2009