How To Replace Pci Cards - Tekelec 1100 Hardware Manual

Hardware Manual
3. Insert your index finger into the ring and pull the module out of the unit.
Be sure to support the unit with your hands as it is pulled completely out of the chassis.
CAUTION: Be sure to use two hands when you are supporting the power supply
modules.
4. Insert the new power supply module.
As the module engages the connector, the locking ring will cam and rotate upward slightly.
5. While pushing the new module in, rotate the locking ring upward until the unit is fully engaged
with the chassis and the locking ring is flush with the edge of the power supply module.
6. If requested, return the failed fan assembly to Tekelec.
Arrange the return shipment by using the procedures in
11.
7. This procedure is complete.

How to Replace PCI Cards

Use the procedure in this section for either of the following purposes:
To replace a failed PCI card
To remove PCI cards from a failedT1100 AS chassis and place them in a replacementT1100 AS
chassis
1. Do one of the following:
a) If this procedure is being performed to move PCI cards from a failedT1100 AS chassis to
the replacementT1100 AS chassis, skip to the next step.
910-2969-001 Revision K, June 2009
Field Replaceable Units
Hardware Repair and Return on page
129