Mitsubishi Electric M700VS Series Setup Manual page 7

1. Items related to product and manual
If the descriptions relating to the "restrictions" and "allowable conditions" conflict between this manual
and the machine tool builder's instruction manual. the latter has priority over the former.
The operations to which no reference is made in this manual should be considered "impossible".
This manual is complied on the assumption that your machine is provided with all optional functions.
Confirm the functions available for your machine before proceeding to operation by referring to the
specification issued by the machine tool builder.
In some NC system versions. there may be cases that different pictures appear on the screen, the machine
operates in a different way on some function is not activated.
2. Items related to faults and abnormalities
If the battery low warning is issued, save the machining programs, tool data and parameters in an input/
output device, and then replace the battery. When the battery alarm is issued, the machining programs, tool
data and parameters may have been destroyed. Replace the battery and then reload the data.
3. Items related to setup
Always set the stroke end and stroke limit. Failure to set this could result in collision with the machine end.
Do not adjust the spindle when possible risks associated with adjustment procedures are not thoroughly
taken into consideration.
Be careful when touching spindle's rotating section, or your hand may be caught in or cut.
The analog output R registers are allocated in ascending order of channels and station numbers
automatically. Therefore, the analog output destination may change depending on the added option.
CAUTION
[Continued to next page]