Mitsubishi Electric M700VS Series Setup Manual page 371

MITSUBISHI CNC
Appendix 1 Explanation of Parameters
【#3017】 stapt 1 Tap time constant (Gear: 00)
Set the time constant for constant inclination synchronous tapping cycle with gear 00 (linear
acceleration/deceleration pattern).
---Setting range---
1 to 5000 (ms)
【#3018】 stapt 2 Tap time constant (Gear: 01)
Set the time constant for constant inclination synchronous tapping cycle with gear 01 (linear
acceleration/deceleration pattern).
---Setting range---
1 to 5000 (ms)
【#3019】 stapt 3 Tap time constant (Gear: 10)
Set the time constant for constant inclination synchronous tapping cycle with gear 10 (linear
acceleration/deceleration pattern).
---Setting range---
1 to 5000 (ms)
【#3020】 stapt 4 Tap time constant (Gear: 11)
Set the time constant for constant inclination synchronous tapping cycle with gear 11 (linear
acceleration/deceleration pattern).
---Setting range---
1 to 5000 (ms)
【#3021】 sori Orientation rotation speed
Set the spindle orientation speed.
Set the speed for when the spindle rotates at the constant speed.
---Setting range---
0 to 32767 (r/min)
【#3022】 sgear Encoder gear ratio
Set the gear ratio of the spindle to the detector.
Setting value 0 ---> Detector : Spindle = 1:1
Setting value 1 ---> Detector : Spindle = 1:2
Setting value 2 ---> Detector : Spindle = 1:4
Setting value 3 ---> Detector : Spindle = 1:8
This parameter is enabled only when "S-analog" is set by the spindle connection parameter "#3024
sout".
---Setting range---
0 to 3
【#3023】 smini Minimum rotation speed
Set the minimum spindle speed.
If an S command below this setting is issued, the spindle will rotate at the minimum speed set by this
parameter.
---Setting range---
0 to 32767 (r/min)
【#3024(PR)】 sout Spindle connection
Select the type of interface with a spindle drive unit.
0: No connection with a spindle
1: Dedicated network, dedicated optical communication
2 - 5: S-analog
---Setting range---
0 to 5
354