Mitsubishi Electric M700VS Series Setup Manual page 297

MITSUBISHI CNC
Appendix 1 Explanation of Parameters
【#1574】 Ret2 Return type 2
Select the axis to be moved later after tool return.
This is referred to with the movement path (return start point -> transit point #2).
Up to eight axes can be specified by expressing one axis with one bit.
bit0 : Transit point #2 1st axis
bit1 : Transit point #2 2nd axis
bit2 : Transit point #2 3rd axis
bit3 : Transit point #2 4th axis
bit4 : Transit point #2 5th axis
bit5 : Transit point #2 6th axis
bit6 : Transit point #2 7th axis
bit7 : Transit point #2 8th axis
---Setting range---
00000000 to 11111111 (Binary)
【#1590】 Animate ax direct Machine status animated display axis direction(+/-)
<bit0>
0: 1st axis + direction is set to the right direction.
1: 1st axis + direction is set to the left direction.
<bit1>
0: 2nd axis + direction is set to the rear direction.
1: 2nd axis + direction is set to the front direction.
<bit2>
0: 3rd axis + direction is set to the top direction.
1: 3rd axis + direction is set to the bottom direction.
【#1591】 Animate ax-1 Machine status animated display axis name (1st axis)
Set the name of the 1st axis displayed with the machine status animation. When the axis name is not
specified, the current 1st axis name ("#1013 axname") will be used.
---Setting range---
Axis name such as X, Y, Z
【#1592】 Animate ax-2 Machine status animated display axis name (2nd axis)
Set the name of the 2nd axis displayed with the machine status animation. When the axis name is
not specified, the current 2nd axis name ("#1013 axname") will be used.
---Setting range---
Axis name such as X, Y, Z
【#1593】 Animate ax-3 Machine status animated display axis name (3rd axis)
Set the name of the 3rd axis displayed with the machine status animation. When the axis name is
not specified, the current 3rd axis name ("#1013 axname") will be used.
---Setting range---
Axis name such as X, Y, Z
【#1901(PR)】 station addr
Not used. Set to "0".
280