Mitsubishi Electric M700VS Series Setup Manual page 303

MITSUBISHI CNC
Appendix 1 Explanation of Parameters
【#11034】 G12AddrCheckType Command address type to check in circular cutting
Select the type of command address to check in circular cutting.
0: Regard command addresses other than D, F, I as illegal.
1: Regard the command address H as illegal. And commands other than D,F,I and M,S,T,B are
【#11035】 Sys. change limit Part system switching restriction
This restricts switching the part systems displayed on screen.
0: Not restrict
1: Disable the part system switching by pressing [$<->$] key on touch panel.
2: Disable the part system switching by display switch signals(Y730 to Y733).
【#11036】 meas dir judge Non-sensitive band for manual measurement direction judgment
(for M system only)
Set the non-sensitive band to be used for judging the manual measurement direction. If the feedback
position fluctuates widely at the axis stop, set the fluctuation width or larger value in this set the
parameter.
When set to "0", the band will be 1(um).
---Setting range---
0 to 1000(um)
0: 1(um)
【#12001】 ManualB RectanA xH Manual feed rate B constant surface control intersecting
part system axis name (horizontal)
Set the part system axis name ("#1013 axname") for the two axes that intersect with the rotary axis
direction. When one of the two axes is blank, a constant speed will be applied without using constant
surface speed control.
---Setting range---
Axis addresses such as X, Y, Z, U, V, W, A, B, and C
【#12002】 ManualB RectanA xV Manual feed rate B constant surface control intersecting
part system axis name (vertical)
Set the part system axis name ("#1013 axname") for the two axes that intersect with the rotary axis
direction. When one of the two axes is blank, a constant speed will be applied without using constant
surface speed control.
---Setting range---
Axis addresses such as X, Y, Z, U, V, W, A, B, and C
【#12003】 ManualB RotCent erH Manual feed rate B constant surface control rotation center
machine position (horizontal)
Set the machine coordinate position (horizontal axis) at the center of the rotary axis.
---Setting range---
-99999.999 to 99999.999 (mm)
【#12004】 ManualB RotCent erV Manual feed rate B constant surface control rotation center
machine position (vertical)
Set the machine coordinate position (vertical axis) at the center of the rotary axis.
---Setting range---
-99999.999 to 99999.999 (mm)
【#12005(PR)】 Mfig Number of M
Set the number of M that can be specified within the same block.
---Setting range---
1 to 4
286
disabled.