Mitsubishi Electric M700VS Series Setup Manual page 263

MITSUBISHI CNC
Appendix 1 Explanation of Parameters
【#1220】 aux04 (for L system only)
bit 0: Tool life check timing selection
Select the criterion to judge the tool life end when the use count is incremented in tool life
management II.
0: Determine the tool life end when the incremented use count has exceeded the life count.
1: Determine the tool life end when the incremented use count has reached the life count.
【#1221】 aux05
bit0: Workpiece coordinate/ Absolute coordinate display switching
Select the coordinate to display when workpiece coordinate position counter is selected for the
Monitor screen counter display.
0: Workpiece coordinate
1: Absolute coordinate
【#1222】 aux06
bit4: Minimum cut-in amount selection
Select the minimum cut-in amount command value for the compound thread cutting cycle (G76
command).
0: The minimum cut-in amount (Q) will be "0".
1: The minimum cut-in amount (Q) will be set in the CNC internal data.
bit5: Fixed cycle for compound lathe command format check selection
Select the operation when the 1st block of the fixed cycle for compound lathe is omitted while the
conventional format is selected ("#1265 ext01/bit0" is set to "0").
0: Program error (P33) will occur.
1: Parameter setting value will be used.
bit7: Reference position return deceleration check method
Select the deceleration check method to be used during automatic reference position return.
0: In-position check
1: Commanded deceleration check
246
(Default)
(Use count > life count)
(Use count ≧ life count)