Mitsubishi Electric M700VS Series Setup Manual page 241

MITSUBISHI CNC
Appendix 1 Explanation of Parameters
【#1037(PR)】 cmdtyp Command type
Set the G code list and compensation type for programs.
1 : List1(for M)
2 : List1(for M)
3 : List2(for L)
4 : List3(for L)
5 : List4(for special L)
6 : List5(for special L)
7 : List6(for special L)
8 : List7(for special L)
9 : List8(for M)
10 : List8(for M)
There are some items in the specifications that can be used or cannot be used according to the
value set in this parameter.
The file structure may also change depending on the compensation data type.
【#1038】 plcsel Ladder selection
Not used. Set to "0".
【#1039(PR)】 spinno Number of spindles
Select the number of spindles.
0: No spindle
1 to 6: One to six spindles
(Note) The setting range differs according to the model.
【#1040(PR)】 M_inch Constant input (inch)
Select the unit system for setting and display regarding machine parameter and PLC interface's
position, length and speed.
0: Metric system
1: Inch system
【#1041(PR)】 l_inch Initial state (inch)
Select the unit system for the program travel amount when the power is turned ON or reset and for
position display.
0: Metric system
1: Inch system
(Note) The units of the following data are converted by "#1041 I_inch".
- Command unit at power ON and reset (Inch/metric command mode)
- Unit system for position display (counter, user parameter, tool, work offset)
- User parameter I/O unit
- Parameter unit of user parameters concerning length and speed
- Arc error parameter (#1084 RadErr)
- PLC interface unit related to function manual arc feed
【#1042(PR)】 pcinch PLC axis command (inch)
Select the unit system for the commands to the PLC axis.
0: Metric system
1: Inch system
224
Type A (one compensation amount for one compensation No.)
Type B (shape and wear compensation amounts for one comp. No.)
Type C (shape and wear compensation amounts for one comp. No.)
Ditto
Ditto
Ditto
Ditto
Ditto
M2 form at type A
(one compensation amount for one compensation No.)
M2 form at type B
(shape and wear compensation amounts for one compensation No.)
But under the following conditions, the unit will follow G20/G21 command modal even at
reset.
When reset modal is retained ("#1151 rstint"="0")
When G code group 06 reset modal is retained ("#1210 RstGmd/bit5" ON)
Type A
Type B