Mitsubishi Electric M700VS Series Setup Manual page 129

MITSUBISHI CNC
10 Setting the Deceleration Check
(2) In-position check
When the in-position check is valid, the command deceleration check is carried out. After that, it is confirmed that
the servo system positional error is less than the parameter setting value, and the next block is executed.
The in-position check width can be designated with the servo parameter in-position width (SV024). Note that G0
and G1 can be designated independently with the axis specification parameter G0 in-position check width (G0inps)
and G1 in-position check width (G1inps). If both the servo parameter and axis specification parameter are set, the
larger value will have the priority.
Speed
If the SV024 setting value is larger, in-position check will end when the SV024 setting value is established.
112
G0inps(G1inps)
SV024
Time
ON
OFF
Command to motor
Motor speed
Next block command
Judge completion of deceleration with
G0inps (G1inps) setting value
Deceleration check signal